Continuum S2 Phono Settings

If the Phono Card option has been factory installed, so that INPUT 1 on the rear of the Continuum S2 Preamplifier is dedicated for phono operation only, the following adjustments can be made to optimize the performance of a particular phono cartridge. These adjustments include both cartridge loading and overall phono amplifier gain.

Moving Coil 100 Ohms

Moving Coil 400 Ohms

High Output Moving Coil

Moving Magnet


CAUTION: Do not select the 47K ohm Load Switch Position unless a turntable, phono cartridge or RCA “shorting plug is connected to INPUT1!


CAUTION: If a phono turntable or RCA “shorting” plug is not connected to INPUT 1/and the card is installed, set the Load Switch Position to any position except 47K. The 47K ohm Load Switch Position is used for Moving Magnet or High Output Moving Coil phono cartridges only!


Related Articles

No related articles were found.

Attachments

No attachments were found.

Visitor Comments

Article Details

Last Updated
18th of November, 2013

Would you like to...

Print this page  Print this page

Email this page  Email this page

Post a comment  Post a comment

 Subscribe me

Subscribe me  Add to favorites

Remove Highlighting Remove Highlighting

Edit this Article

Quick Edit

Export to PDF


User Opinions



How would you rate this answer?




Thank you for rating this answer.

Continue